Issue Summary

• "Page Properties Report" macro can be added into a table on a page.
• The table can be wrapped in a "Page Properties" macro.
• But using another "Page Properties Report" to display the "Page Properties" macro above, the results from the "Page Properties Report" macro is not shown.
• This is reproducible on Data Center:
  • No.
• Editor:
  • Legacy and current editor.

Steps to Reproduce

1. Create a new page: Page 1.
   • Add the label, "Page1".
2. Add the "Page Properties" macro.
   • Add a table with some values in it.
   • Publish the page.
3. Create another page: Page 2.
   • Add the label, "Page2".
4. Add the "Page Properties" macro.
   • Add a table with some values in it.
   • Add the "Page Properties Report" macro into the table as well.
   • Configure the Page Properties Report macro to pull results from the label, "Page1".
   • Publish the page.
5. Create another page: Page 3.
   • Add the "Page Properties Report" macro into the page.
   • Configure the Page Properties Report macro to pull results from the label, "Page2".
6. All other values from the table in Page 2 will show up, except the values from the "Page Properties Report" macro.

Expected Results

• All the values results from the "Page Properties" macro, including the "Page Properties Report" macro, should also be displayed in the "Page Properties Report" macro.

Actual Results

• All other values is shown, except the "Page Properties Report" values.

Workaround

• Currently there is no known workaround for this behavior. A workaround will be added here when available

Note

• A similar issue was reported some time back, and included a workaround.
• But the workaround is no longer applicable, and the bug has been closed.
  • CONFCLOUD-69378